Scubapro Galileo 2 (G2)

Discussion of the iOS App Dive Log
Posts: 3
Joined: Wed Oct 11, 2017 6:47 am

Re: Scubapro Galileo 2 (G2)

Post by TomR » Tue Nov 28, 2017 5:33 am

That’s awesome news!

Thanks Greg!

Posts: 2
Joined: Sun May 20, 2018 5:26 am

Re: Scubapro Galileo 2 (G2)

Post by Sui » Sun May 20, 2018 5:29 am


When i'm downloading the dives, the average depth showed in the app (Iphone) is not the same as showed in the logbook of the G2.

Someone else the same probem?

Why is this so?

Posts: 716
Joined: Wed Mar 31, 2010 4:35 pm

Re: Scubapro Galileo 2 (G2)

Post by support » Sun May 20, 2018 8:28 am

This is most likely being caused by samples that the G2 is recording near the surface that are being used for the average depth calculation in Dive Log but which the G2 is ignoring. You can change the behavior of Dive Log to match that of the G2 by turning on the "Ignore Surface Samples" switch in the Dive Log Settings tab (usually under the "..." or More tab). This will change Dive Log's behavior to only consider samples deeper than 0.5 meters when calculating the average depth. This will affectedly newly downloaded dives directly, however if you want to change the result for previously downloaded dives you'll want to edit the cached "average depth" value for that dive by clearing it (tap the dive metrics and then Edit and then the "-" next to average depth). Dive Log will then dynamically calculate the average depth following the value of the "Ignore Surface Samples" switch.

If you are still finding a discrepancy after that please contact us via our support email address (support 'at' moremobilesoftware 'dot' com) and we can take some additional diagnostics steps.



Posts: 2
Joined: Sun May 20, 2018 5:26 am

Re: Scubapro Galileo 2 (G2)

Post by Sui » Sun May 20, 2018 8:50 am

Thanks for the fast reply!

I did it for some dive. The differnce is now smaller. It was up to 2m before, now around 20-40cm difference. Thats fine for me.

Great app!

Post Reply